99800mAh 12V Car Jump Starter Pack Booster Charger Battery Power Bank AU Plug
99800mAh 12V Car Jump Starter Pack Booster Charger Battery Power Bank AU Plug
Feature:
1.Small and light size, easy to carry.
2.High power battery: support fast charge.
3.Support 12V vehicle jump start and charge for various cell phones, PSP, MP3/MP4, PDA, laptop, car refrigerator and so on.
4.Support 3 kinds of LED lighting modes: lighting mode, flash mode, SOS mode.
5.Multiple safety protections design.
6.Diesel and gasoline are universal.
7.Cold and high temperature resistant, can work in the environment of -40℃~80℃.
8.Multifunctional USB port.
9.The necessary compass for mountaineering, camping and other outdoor activities.
10.Waterproof and dustproof.
11.The battery capacity is large, durable and safe.
12.Providing power to the car, starting the car in a flash, simply solving the dilemma.
13.Easy to use, no need to install, no need to set up, just use a clip to connect the car positive and negative, turn the power on, the car can start (red - positive, black - negative).
Specification:
Material: ABS
Capacity: 99800mAh
Working Temperature:-20℃-60℃
USB Output: 5V-2A
Laptop Output: 12V-16V-19V
Input Current: 15V/1A
Three Lighting Mode: LED torch light, red and blue lights, SOS LED explosion-flashing
Applicable Vehicle: Gasoline car 6.0，Diesel-engined car 4.0
Starting Current: 300A
Peak Current: 600A
Plug: AU
Recommendation:
When you receive the device, it’s best to discharge the built-in lamp/torch for a short time, then fully charge the jump starter for at least 4 hours before using it to start a vehicle.
Ensure the jump starter’s battery level is at least 3 bars or around 60% or more before attempting a jump-start.
Check the vehicle battery terminals (the posts) — make sure they are clean, free of corrosion, and the clamps will make solid contact.
Using the standard clamps:
Make sure the clamp plug into the jump starter is fully inserted (blue or other colour port as applicable).
Ensure each clamp contacts the battery terminals with maximum contact area, is firmly attached, and there’s no wobble.
Connect the positive clamp to the battery’s positive (+) terminal. Then connect the negative clamp to the battery’s negative (–) terminal (or as per manufacturer/vehicle instructions).
Wait 2-3 minutes after connecting the clamps before trying to start the car — this helps relieve some load on the jump starter.
Once the vehicle starts, disconnect in the correct order (usually negative clamp first, then positive) and allow the vehicle to idle or drive to recharge its battery.
Four practical functions: